Ford Automatic Transmission Control Module Programming / Cloning DPS6 DCT250 ECU TCU

£200.00

MotorTronics provides a prompt programming solution for your electronic modules. The modules go through various data cloning processes to ensure all data is extracted / matched or modified to be plug and play. Only after this, we pass it and it’s ready for dispatch.

All that is left for you to do is:

1. Click Buy it Now / Add to Cart.
2. Fill in the Repair Form provided after the payment page, also emailed.
3. Send your original module (Marked Original) and replacement module (Marked Replacement) with the Repair Form.
4. Await programming while we have your part(s).
5. Once received, simply plug it in and turn the key.
6. In some cases, you will require diagnostics to adapt / clear codes.

Description

Ford Automatic Transmission Control Module Programming / Cloning DPS6 DCT250 ECU TCU

This is a Programming Service for Ford DPS6 DCT250 Automatic Transmission Control Module ECU / TCU 

These units need programming to your specific Ford since the must have the correct Vin and Assembly line data to correctly function. we offer the best cost effective method, our equipment is able to extract the vital data from your old unit and we are then able to use that data on a replacement unit, 

The common fault with these TCU’s are the internal sensors and drivers that fail causing no reading / incorrect gear changes / clutch operations  to be provided to the vehicle, which then causes the gearbox not to change gears and get stuck on limp mode or limited number of gears.

The typical error code that show up in the diagnostic are:

  • P0606 – Processor control module.
  • P2837 – Shift Fork “B” Position Circuit Range/Performance.
  • P06B8 – Internal Control Module Error
  • U0101 – Lost Communication with TCM.

These Gearboxes are fitted on many fords such as: Focus, Fiesta, B Max, and many others that gear the same DPS6 gearbox.